SRC-300a Residential Gateway PBTV Remote
Power and Volume
- Start with the TV turned on.
- Press the LED button and hold it down until the
LED flashes rapidly.
- Press the RECORD button (the button with the red oval above the FAV button). The LED stops blinking at
this point and stays solid.
- Press and release the POWER button. The TV is
now in TV code scan programming mode.
- Press the UP ARROW button to scan through all
the TV codes. When you reach the correct TV
code, the TV will automatically turn off. Note that
the LED will flash rapidly once you have scanned
through all the codes, and then it will continue to
go through the codes again in a continuous wrap.
- Press the SELECT button to store the TV code.
The LED flashes rapidly then stops, indicating that
the TV code has been stored.
If you press the UP ARROW button too rapidly,
you may pass the TV code before the time the TV
turns off. If you are not sure you are storing the
correct TV code, press the DOWN ARROW
button slowly to cycle back through codes that
have been previously scanned. When the TV turns off, press the SELECT
button to store the TV code.
finding Your 3 Digit Gatway ID
This will only work on your TV that is set to the Channel 3 video stream.
- Press MENU or the wrench button (
) on the Gateway.
- A menu will appear on the channel 3 TV. Arrow down on the menu to Remote Control Setup and press Select.
- Press the PPV button and the Gateway ID will appear on the screen.
Setting the Operating Mode
- Press and hold the LED key until it starts to blink.
- Press the REC key. The LED stays solid.
- Press and release the D key.
- Press 0
Setting the Gateway ID
- Press the LED key and hold it down until the LED light flashes rapidly.
- Press the REC key. The LED stays solid.
- Press the B key.
- Enter the 3 digit gateway id number.
Setting the Stream
- Press the LED key for 3 seconds until LED flashes.
- Press the REC key. The LED stays solid.
- Press the A key.
- Enter the single-digit remote control ID.
Remote
Control ID |
Operates TV |
| 0 |
Your TV and Gateway are in the same
room and TV is on channel 3 |
| 1 |
Your TV operates on channel 3
and Gateway is in another room |
| 2 |
Your TV operates on channel 10 |
| 3 |
Your TV operates on channel 13 |
Additional Residential Gateway Remote Control Setup and Troubleshooting
